3 Methods to Clean a Ceramic Pipes

Method 1: Use of Rubbing Alcohol


Removing any loose filth from the pipe.
Simply hold the pipe in an up-side-down position, then tap gently to remove any of the loose particles. Use a pipe cleaner, mechanical pencil, needle, cotton swab or maybe a thin object to remove the large and easily extricated resin bits within reach.

Fill a sealable plastic bag with rubbing (isopropyl) alcohol
Buy 90% isopropyl, it cleans the ceramic pipe even faster than a 71% watered-down solution. Ensuring it is fully submerged. Alcohol has the property to break down the resin and tar.

Add one tablespoon of salt to the plastic bag
Here, the salt will act as the abrasive sponge on the pipe, thus scrubbing away resin in the places you could not reach using the brush or sponge. Kosher or coarse salt is the best option to use.
Shake the pipe inside the bag, ensuring the salt reaches inside of your pipe
It’s advisable to shake the bag for about 1 to 2 minutes, or until the pipe becomes visibly clean.

Soak the pipe for long hours to remove very dirty pipes

Add a plop of fresh isopropyl then let the pipe sit, submerged inside the fluid for relatively many hours before you shake it again. For 71% isopropyl alcohol, you’ll have to add a little more salt.

Rinse the pipe using hot water
After removing all the salt and alcohol from the ceramic pipe, discard everything else into the toilet.
Use cotton swabs or pipe cleaner to clean the remaining spots

 

 

Method 2: Use of Boiling Water


Remove any protracted ash or gunk
Perform a quick and basic pipe cleaning by knocking out all the loose resin with a cotton swab wiping and dislodging any larger gunk particles. Don’t use cold water.
Boil some water in a pot
Ensure the water is enough to cover up the whole pipe, if possible by about 3–4 inches to be safe.
Submerge the pipe in water
The pipe must be fully submerged in the water, and as it boils and evaporates, be around to ensure your pipe do not remain alone inside the hot pan, it may crack.
Let the pipe sit in simmering water for 20–30 minutes
Remove the pot from heat the check whether the pipe still has some residue. Since it will be so hot, use oven mitt to check it, but do not douse the ceramic pipe in cold water, it will shatter.

Use cotton swab or pipe cleaner to remove any excess residue
In case it has some water stains, soak the pipe in a mixture of lemon juice and 2–3 tablespoons of clean water and allow it to air dry.

 

 

Method 3: Use of Alternate Cleaning Solution

 

Use denture cleaning tablets
Place your pipe at the bottom of a Tupperware, then fill it with hot water covering the top. Then put in 2–3 denture tabs and allow it to sit and soak for about 30 minutes. Other domestic leaning methods include; salt and vinegar, baking soda and vinegar and sand and water.

Buy specialty cleaning solutions
Products such as simple green and formula 420 are meant for cleaning ceramic pipe resins. However, they are more expensive than the DIY solutions.

Freezing the pipe makes the resin to harden and dry, and that makes them easy to dislodge. This should take about 30 minutes, then you can use some sharp or thin object to knock the resin.

Regular cleaning of the pipe
You can be take care of ceramic pipe at least once every week for just five minutes by rinsing and soaking the pipe in some isopropyl. This will keep you from deep cleaning and overnight soakings.